Dear Tohbans

I would like to re-point Yohkoh tomorrow by about 10 arc sec by
executing a new NORML PNT command, ROG #032 (dec). Please upload
OP+OG and issue the ROG#32 at the time specified in the command 
sheets. Because the motion will be small, you may not be able to
confirm directly by watching the image move.

The details below are just my worksheet for doing the calculation for
the new OG contents.

Thanks

SXT_CO Hudson


++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

1) term_review, /compare, /set

Increment Euler Angles (X,Y) by [8.26", -4.75"]

2) point_hex2 to generate the current OG#32

IDL> point_hex2, [-.0972,.0313], /name                    
TARGET ANGLE-X        -0.0972000 (DEG)
TARGET ANGLE-Y         0.0313000 (DEG)
BLOCK COMMAND ===>  81 00 F9 23 02 0D 00 00
     -1.07333   -0.0186599
COMMAND NAME:  S/C  W.018 N1.07            (offset angles in arcmin)
 
----- OG EDITOR OUTPUT ---------------
 
 NUMBER :      NAME : S/C W.018 N1.07
 
  1  04-DC-8A  ACS: ACP DATA SET+B7
  2  04-BC-81  ACS: BC
  3  04-BC-F9  ACS: BC
  4  04-BC-23  ACS: BC
  5  04-BC-02  ACS: BC
  6  04-BC-0D  ACS: BC
  7  04-BC-00  ACS: BC
  8  04-BC-00  ACS: BC
  9  04-DC-11  ACS: BC EXEC     +++

3) point_hex2 to generate the new OG#32

IDL> point_hex2, [-.0972+8.26/3600,.0313-4.75/3600], /name
TARGET ANGLE-X        -0.0949056 (DEG)
TARGET ANGLE-Y         0.0299806 (DEG)
BLOCK COMMAND ===>  81 00 F9 4C 01 F5 00 00
    -0.935667   -0.0978266
COMMAND NAME:  S/C  W.097 N.935            (offset angles in arcmin)
 
----- OG EDITOR OUTPUT ---------------
 
 NUMBER :      NAME : S/C W.097 N.935
 
  1  04-DC-8A  ACS: ACP DATA SET+B7
  2  04-BC-81  ACS: BC
  3  04-BC-F9  ACS: BC
  4  04-BC-4C  ACS: BC
  5  04-BC-01  ACS: BC
  6  04-BC-F5  ACS: BC
  7  04-BC-00  ACS: BC
  8  04-BC-00  ACS: BC
  9  04-DC-11  ACS: BC EXEC     +++

4. ROG #32 new name: NML N.937W.097